ORIGAMI | Table Lamp E14, E26, E27

简介

ORIGAMI | Table Lamp E14, E26, E27 print-in-place (NOTE: this version has been entirely replaced by the ORIGAMI STILT version (https://cults3d.com/en/3d-model/home/origami-stilt-table-lamp-e14-e26-e27-print-in-place), fixing some design issues and adding some cooler bases.) Here is a long-awaited update of the print-in-place ORIGAMI table lamp: - First, I reworked the design so there wouldn't too sharp edges, which caused some print defects in the the previous versions. - Then, I added 2 bases that can be be "fixed" on the shade (the shade would just rest on the base in previous versions). - the bases have thicker legs than before, no sharp edges anymore, and print very nicely. - These bases come in low and tall versions. - Also, *the shade comes in 2 sizes**, to fit on most printers out there. You can use the shade with or without the base. If without without the base, just mount your E14 or E26 or E27 bulb sockets directly where the shade's inner shell narrows into a mounting neck in the middle. Or mount the shade on a base and, if you fancy, even mount it all on some table lamp stand or floor lamp stand from IKEA. 2 shade sizes available: - Large version (height 250mm) - Small version (height 209mm) to accomodate smaller printers. Both sizes work with either E14, E26 or E27 sockets. The middle opening fits the E26 / E27. For E14, just print 2 adapter discs (STL provided) , and place them above and below the narrow neck inside the shade. You can get the power cords from…