Lithophane Box

简介

http://www.facebook.com/JSQUAREDPRINTS TO DO YET Add Switch to Battery Version Make Compartment sized for common RGB Strips plug (the four pin) Increase tolerances on the posts as it's very tight side to side Recess Bolt Heads on lid Fix the slight hole/overlap from barrel plug hole Add Magnetic Lid to hot swap panels quickly Box Settings: All M3 Hardware. I will be using M3 x 20 for everything to keep is simple. The stand print settings are not as important. I used 0.3mm layer height at 10% infill. Barrel Version uses 5.5 x 2.1 mm Barrel. Barrel tolerances are tight. I sanded the plastic on the barrel on all 6 sides and it stays in friction fit. Barrel Version you will want to use the CenterSmall Taller version. Lithophane Settings on http://3dp.rocks/lithophane Used 3dp.rocks/lithophane to create the lithophane models. Photos of my settings attached as well. Printed lithophanes vertically at 0.1mm layer height at 99% infill. MODEL SETTINGS: Maximum Width: 100mm Maximum Thickness: 3mm Thinnest Layer: 0.8mm IMAGE SETTINGS Positive Image Slicer Settings [I used Cura 3.6] Layer Height: 0.1mm (0.12 will help speed it up without losing much detail) Infill Speed: 45mm/s Outer Wall Speed: 35mm Inner Wall Speed: 40mm Top/Btm Speed: 20mm Travel Speed: 100mm/s Photo Settings I use Paint.NET for editing photos. Key is to have the photos as square as possible to achieve a 100x100 output. If using Paint.NET: Click "Image" at the top Click Canvas Size Define your anchor. I usually use…