Broom Wall Mount

简介

Simple Broom holder wall mount. This comes in two parts: The Outer Part: The outer part is relatively simple, you can print it in any rigid material such as PETG or PLA. Just be sure to give it a relatively high infill, like 60%+. The Inner Part The inner part is a bit tricky; Because I wanted to have a snap like effect, I designed the inner diameter to be a bit more narrower than the broom handle I had in mind then I printed it in a flexible material like TPU. Give it an infill of 10% or less (the higher the infill the harder it would be for the broom to slide in and out, I recommend 0%). After Printing Simply glue the inner bit to the inside of the outer bit, drill a little hole in your wall or door of choice, and presto!