简介
3 different sized cubes for calibration. As files indicate. Yes, there are lots of calibration cubes with the same information showing below. It's not hard to design and make cubes and I made them and placed them here primarily for my own convenience. if: e= expected dimension o = observed dimension s = current number of steps per mm then: (e/o) x s = your new number of steps per mm e will always be the value of the size of cube you are calibrating against. o will always be the actual size of the cube you printed. s will be your current setting for the steps/mm. If you print all 3 cubes, the value for your new number of steps/mm should theoretically be the same (or pretty darn close) for all 3. It usually shouldn't be necessary to do all 3.
About this model
3 Cube Calibration is a 免费 3D model in the 其他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
