Alien Runcam Split mounting plate

Alien Runcam Split mounting plate

Kostenlos STL Gadgets
  • 13 Aufrufe

Dieses Modell wird auf Cults3D gehostet. Dateien, Bilder und Lizenzangaben gehören dem ursprünglichen Designer.

Auf Cults3D ansehen ↗

Beschreibung

Mount a Runcam Split on an Impulse RC Alien drone frame using the stock screws. This mount matches the angle of the standard carbon mount, and removes the need for the stock plastic parts. Remove two screws from the back of the runcam. These are replaced by two M2 screws from the Impulse set, with the two tiny O-rings between the plate and the camera. Impulse screws set the angle, and Runcam-provided screws hold the mount from the sides. The new version has four holes for mounting the camera - I'm only using two of them and it's been fine. There if you need them! You might need to tidy the holes up a bit with a careful drill.

About this model

Alien Runcam Split mounting plate is a kostenlos 3D model in the Gadgets category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

Ähnliche Modelle