Alien Runcam Split mounting plate

Alien Runcam Split mounting plate

Ücretsiz STL Gadget ve Aksesuar
  • 12 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Cults3D üzerinde görüntüle ↗

Açıklama

Mount a Runcam Split on an Impulse RC Alien drone frame using the stock screws. This mount matches the angle of the standard carbon mount, and removes the need for the stock plastic parts. Remove two screws from the back of the runcam. These are replaced by two M2 screws from the Impulse set, with the two tiny O-rings between the plate and the camera. Impulse screws set the angle, and Runcam-provided screws hold the mount from the sides. The new version has four holes for mounting the camera - I'm only using two of them and it's been fine. There if you need them! You might need to tidy the holes up a bit with a careful drill.

Bu model hakkında

Alien Runcam Split mounting plate, Cults3D topluluğunda paylaşılan ücretsiz bir Gadget ve Aksesuar 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Cults3D üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller