Hypercube Evolution Corner Bracket w/wire & Reverse Bowden Holder

Beschreibung

I remixed this corner bracket to include a loop on the back for hot end wiring to run through as well as a spot for my PTFE tube that runs from the corner of the machine to the filament sensor on the Titan Aero.this attaches to the upper corner of 3030 extrusion with 4 bolts/m5 t nutsI have also added a wire support that sits on top and uses the 2 bolts going through the top of the corner bracket to hold both pieces in place (I used 5mm x 12mm bolts) This has 3 channels to slide small zip ties through to fasten the hot end wiring and keep it held upright