Hypercube Evolution Corner Bracket w/wire & Reverse Bowden Holder

Hypercube Evolution Corner Bracket w/wire & Reverse Bowden Holder

無料 STL ガジェット
  • 22 閲覧

このモデルは Thingiverse で公開されています。ファイル・画像・ライセンス情報は元の作者に帰属します。

Thingiverse で見る ↗

説明

I remixed this corner bracket to include a loop on the back for hot end wiring to run through as well as a spot for my PTFE tube that runs from the corner of the machine to the filament sensor on the Titan Aero.this attaches to the upper corner of 3030 extrusion with 4 bolts/m5 t nutsI have also added a wire support that sits on top and uses the 2 bolts going through the top of the corner bracket to hold both pieces in place (I used 5mm x 12mm bolts) This has 3 channels to slide small zip ties through to fasten the hot end wiring and keep it held upright

About this model

Hypercube Evolution Corner Bracket w/wire & Reverse Bowden Holder is a 無料 3D model in the ガジェット category, shared by the Thingiverse community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Thingiverse. Use the button above to open the original page and download it.

類似モデル