Customizable Hinge cover for cutback doors
- 24 閲覧
このモデルは Cults3D で公開されています。ファイル・画像・ライセンス情報は元の作者に帰属します。
Cults3D で見る ↗説明
We had a reduced width cupboard built as part of our kitchen refit. The doors needed cutting down which meant that the original hinge pockets couldn't be used. The fitter drilled new pockets but couldn't cover the original holes. Sounds like a job for the printer. Measure the length of the cut edge (see photo) and use this value in the customzer / SCAD file. If the cutout is more than half the hinge pocket width then use -xx, but watch out for strange results if you opt for locating studs. Asking for a cut length greater than the diameter has been error trapped. Studs or pips can be included to help with aligning the cover. The program will allow a complete cover (like those supplied) so you can print normal caps to match too.
About this model
Customizable Hinge cover for cutback doors is a 無料 3D model in the その他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
