説明
This was a project for Francisco de Vitoria University in a 1:1 scale. Designed and manufactured by Miguel Blasco, Juan Ignacio Jimenez and Andrés Martinez. The wing is 1400mm long and is divided in 7 different parts with male-female adaptation for sticking together. Only 1 copy from each .stl file is necesary to print except for "SOPORTE" "wingpartV2" "endplates" and "piezaenlazecurvatura" that need 2 copys each. The whole wing was put together using cold welding and the screws needed are 5mm diameter. A carbon fiber vinyl was used to give the surface a finish. Supports are needed for the female holes that must lay flat on the bed. Printing height of 290mm required otherwise scaling will be necesary. Infill of 10-15% is recommended due to printing times being very high. CFD tested at 55,56m/s resulting in 688,63 [N] of downforce and 54,75 [N] of drag, aerodynamic efficiency of 3.092. Project LinkedIn: https://lnkd.in/ghMgk2ih
About this model
GT Rear Spoiler / Wing is a 無料 3D model in the その他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
