GT Rear Spoiler / Wing

Açıklama

This was a project for Francisco de Vitoria University in a 1:1 scale. Designed and manufactured by Miguel Blasco, Juan Ignacio Jimenez and Andrés Martinez. The wing is 1400mm long and is divided in 7 different parts with male-female adaptation for sticking together. Only 1 copy from each .stl file is necesary to print except for "SOPORTE" "wingpartV2" "endplates" and "piezaenlazecurvatura" that need 2 copys each. The whole wing was put together using cold welding and the screws needed are 5mm diameter. A carbon fiber vinyl was used to give the surface a finish. Supports are needed for the female holes that must lay flat on the bed. Printing height of 290mm required otherwise scaling will be necesary. Infill of 10-15% is recommended due to printing times being very high. CFD tested at 55,56m/s resulting in 688,63 [N] of downforce and 54,75 [N] of drag, aerodynamic efficiency of 3.092. Project LinkedIn: https://lnkd.in/ghMgk2ih