MPCNC Primo Magnetic Dust Shoe
- 13 閲覧
このモデルは Cults3D で公開されています。ファイル・画像・ライセンス情報は元の作者に帰属します。
Cults3D で見る ↗説明
A further iteration of my MPCNC dust shoe, the brush is held on by magnets and pops off easily so you can see the bit for setup. It uses 12x3mm neodymium magnets. The brush is from McMaster-Carr, part #1469N14 7/32"x3/16" with 1" brush. Only $2.02 for 3ft. plus shipping. I did trim the bristles, 1" was unnecessary, 3/4" is plenty. The brush fits nicely in the slot, no adhesive needed. I used CA glue to hold the magnets, be sure to pay attention to polarity. I used the tube from an old vacuum cleaner, about 32mm outside diameter.
About this model
MPCNC Primo Magnetic Dust Shoe is a 無料 3D model in the その他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
