Raspberry Pi Power Switch Holder

Описание

This is a little holder that fits on the switch that's on some of the power adaptors for the Raspberry Pi. I made this so I could fit the switch to my Ender 3 v2 as I use a Raspberry Pi. When its fitted to the printer it also acts as a strain relief to stop the cable from being yanked out of the Raspberry Pi potentially damaging the power port. I printed this vertical, with a quality setting of 0.2 and with 100% infill. Total time was 1hr 5mins with these settings. Your times might vary depending on other settings used but should be just over an hour to print.