Raspberry Pi Power Switch Holder

Raspberry Pi Power Switch Holder

Ücretsiz STL Gadget ve Aksesuar
  • 15 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Cults3D üzerinde görüntüle ↗

Açıklama

This is a little holder that fits on the switch that's on some of the power adaptors for the Raspberry Pi. I made this so I could fit the switch to my Ender 3 v2 as I use a Raspberry Pi. When its fitted to the printer it also acts as a strain relief to stop the cable from being yanked out of the Raspberry Pi potentially damaging the power port. I printed this vertical, with a quality setting of 0.2 and with 100% infill. Total time was 1hr 5mins with these settings. Your times might vary depending on other settings used but should be just over an hour to print.

Bu model hakkında

Raspberry Pi Power Switch Holder, Cults3D topluluğunda paylaşılan ücretsiz bir Gadget ve Aksesuar 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Cults3D üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller