Y Motor Support

Описание

Support for motor Y. Stabilizes it, prevents the hot bed cable from locking against it. Can be adapted to other printers. As the height depends on each model and if there are attenuators or not, you must adapt the alter, it can be done from the laminator but you have to disable the proportionality as it will change the motor size parameters. It is recommended to use 3 perimeters for greater part strength. WARNING: In my case, my printer has some dampers. So for the standard model you have to reduce its height a little bit. If you print it like this it will be taller than it should be. be careful that the maximum height does not exceed that of the motor, it could jam if under the bed there is a heating plate to maintain the temperature of the bed.