Coil support

Açıklama

FR / EN EN : A simple coil support to be made without a stand Best printed in PETG especially for sliding arms. I used 608 2rs bearings https://www.amazon.de/.../ref=ppxyodtbasintitleo00... With the adjustable screw this will give you a width of 52 to 82 mm. which is quite a bit of possible coil width. I prefer an 80% straight fill. Count 5 h for the two large pieces forming the base. and 2h for the kit: screw, stop, pad. For PETG 230 for the nozzle and 85 for the bed. Don't hesitate to share your achievements with me it's always interesting. Good Print ! EN: A simple supportto be made without a stand Preferably printed in PETG, especially for the sliding arms. I used 608 2rs bearings https://www.amazon.de/.../ref=ppxyodtbasintitleo00... With the adjustable screw this will give you a width of 52 to 82 mm. which is quite a lot of possible coil width. I prefer 80% straight filling. Allow 5 hours for the two large pieces forming the base and 2 hours for the kit: screw, stop, pad. For the PETG 230 for the nozzle and 85 for the bed. Don't hesitate to share your work with me, it's always interesting. Have a good print! 3d #3dprinting #3dart #3dprinted #3dmodeling #3dmodel #3dender #3dprusa #ender3 #prusa #3dmk3s #diy #maker #3dprinter #impression3d #madeinbelgium #ender3 #followme #filament #pla