Carlos Moroder - cmoroder

Açıklama

I own an Ender 6 and I have the Creality Box plus the camIn the end I found what I think it is a good spot position for the cam.The supplement is intended to raise it from the bed and provide certain perspective (angle).It fits perfect and the way to attach the supplement to the profile is by means of silicon glue with a hot gun.No need to add a lot. just two points so it will stay fixed.For slicing, please use brim and supports (2) and follow pictureI must admit that the cam should NOT be attached to the Z axis, as the cam would move with it... The wise thing is to locate it in a non movable area where it is always focusing the hotend, in the case of the Ender 6, BUT they on any where the head is attached to the Z Axis, that would be the right position.Be careful using it for ABS, let alone if the Ender 6 is completely covered... you can get temperatures of 60 degrees in the cabin that may harm the device.Any improvements will be appreciated