Update for Bambu Lab setup

Açıklama

Update for Bambu Lab setup for AMS with LED / RGB / coils / coil holder. Hello The update is about 3 different parts 1 - Update: New upper rim 2 - Update: Trash chute with trash box. 3 - Update: Teflon pipe holder / insertion helper. Updates videos https://youtu.be/LHVRvTivTgM Update 1 I designed the new wreath because not everyone who owns a Bambu Lab printer also owns an AMS. I own an AMS, but I don't really use it because I prefer the direct feed. On the other hand, there are certainly many users who prefer to have the AMS set up next to the printer. The new rim has the advantage that you have a better top view of the printed material and, more importantly, that when you take the disc out completely, the accumulated heat can escape better. For installation: Just unscrew the old parts and replace them with the new parts, the nuts and bolts will be reused. To the 4 parts that need to be replaced 1 - 1 - Update without AMS - Wreath top - Left - 140g 1 - 2 - Update without AMS - Wreath top - Right - 96g 1 - 3 - Update without AMS - Wreath top -Rear - Left - 91g 1 - 4 - Update without AMS - Wreath top -Rear - Right - 66g Update 2 Update for the Bambu Lab X1-Carbon I designed the waste chute for the filament because my furry roommates always think there treats fall into the bin. With the waste chute with waste box that I designed, my cats have not even managed to get to the filament because everything is covered and sits behind a screen. However, you can still get to the waste…