Anycubic Mega S Top Mount Spool Filament Guide

Açıklama

Anycubic Mega S Top Mount Spool Filament Guide I switched my Mega S over to the MK4 Direct Drive and found the filament all over the place and rubbing up against the spool holder mount. So I designed this filament guide to work with the Anycubic Mega/S General Mounting System (https://www.thingiverse.com/thing:4865663) I had designed earlier. Notes My bowden tube has an OD of 4.1 mm. The tube slides in with gentle pressure. If it's tight for you, you can drill the hole out a bit or, preferably, you can adjust Hole horizontal expansion setting in Cura (mine is set to 0.1 mm). If it's loose for you, use a drop of super glue. I'm using a 35 mm piece of tubing, but you can use any size greater or equal to 13 mm. Instructions 1. Mount top-beam-mount-1sided-ALT-v2b.stl onto the printer. 2. Glue filament-guide.stl onto attachment-v2.stl. 2. Slide attachment-v2.stl into top-beam-mount-1sided-ALT-v2b.stl. If you found these parts useful, please Like and post a Make. Thanks!