ESP32 Camera Case

ESP32 Camera Case

Ücretsiz STL Düzenleyici ve Saklama
  • 26 görüntülenme

Bu model Thingiverse üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Thingiverse üzerinde görüntüle ↗

Açıklama

Remix of Thing 3541406I added holes in the lid for a 2 pin DuPont connector which can power the camera with +5V and Ground, as well as a small mounting screw hole. I moved the SD card slot upwards from the front a little to give room for the camera module which sits in front of the SD card slot, and adjusted the flash position slightly. I also changed the print to not require any bridging while printing. The part of the case above the SD card slot is now part of the lid print. I also slightly reduced and moved the camera hole to better match the ESP32 camera pieces that I have. The overall fit is far superior now, and using a 2 pin DuPont connector for power works well for me.

Bu model hakkında

ESP32 Camera Case, Thingiverse topluluğunda paylaşılan ücretsiz bir Düzenleyici ve Saklama 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Thingiverse üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller