Protractor-Angle Checker

Protractor-Angle Checker

Ücretsiz STL Diğer
  • 28 görüntülenme

Bu model Thingiverse üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Thingiverse üzerinde görüntüle ↗

Açıklama

There are two kinds to choose from.Print the pdf file with the protractor with out any scaling and it should fit the printed base. Cut out and glue to the base. Layer on top of it with clear tape if like. Contact glue works great.Bend the pointer up where the printed marks are on it. May cut it off and use tape so it will hinge well. I used contact glue and a piece of cloth. The cloth will last forever.Hardest part is cutting out the pdf and glueing it to the base. Use a standard square or known perfect square in lining up.Check out also my other design.https://www.thingiverse.com/thing:7379117Should print fine.Enjoy, Rick.

Bu model hakkında

Protractor-Angle Checker, Thingiverse topluluğunda paylaşılan ücretsiz bir Diğer 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Thingiverse üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller