Refoss EM16 Antenna Bracket

Refoss EM16 Antenna Bracket

Ücretsiz STL Düzenleyici ve Saklama
  • 33 görüntülenme

Bu model Thingiverse üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Thingiverse üzerinde görüntüle ↗

Açıklama

I have a Refoss EM16 energy monitor. My breaker panel is set inside the wall, so I can't stick the antenna into a knockout hole on the side of the panel. I designed this bracket so I can mount the antenna to the wall next to the panel.The hole in the top is 3/4" (19mm) which is a nice snug fit for the rubber grommet on the antenna. I also added clips to the bottom to hold the wire close to the wall.There are 3 versions. There is one for machine screws, one for countersunk screws, and one with no holes for double sided tape.

Bu model hakkında

Refoss EM16 Antenna Bracket, Thingiverse topluluğunda paylaşılan ücretsiz bir Düzenleyici ve Saklama 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Thingiverse üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller