Refoss EM16 Antenna Bracket

Refoss EM16 Antenna Bracket

免费 STL 收纳整理
  • 32 次浏览

该模型托管于 Thingiverse。文件、图片及许可信息归原创作者所有。

在 Thingiverse 查看 ↗

简介

I have a Refoss EM16 energy monitor. My breaker panel is set inside the wall, so I can't stick the antenna into a knockout hole on the side of the panel. I designed this bracket so I can mount the antenna to the wall next to the panel.The hole in the top is 3/4" (19mm) which is a nice snug fit for the rubber grommet on the antenna. I also added clips to the bottom to hold the wire close to the wall.There are 3 versions. There is one for machine screws, one for countersunk screws, and one with no holes for double sided tape.

About this model

Refoss EM16 Antenna Bracket is a 免费 3D model in the 收纳整理 category, shared by the Thingiverse community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Thingiverse. Use the button above to open the original page and download it.

相似模型