ExoBass - Neck - Neck v4

Açıklama

Part of the ExoBass project — full catalog, build planner, and assembly guides at https://exobass.comPlan Your Build & Get HardwareExoBass can be confusing! Head over to our build planner to plan your entire build - it'll walk you through every available part and handle compatibility along the way, and it covers all ExoBass parts. It's also the best way to get hardware, since it lets you buy everything for a full build in one go, not just this part.You can find this specific part, ExoBass - Neck - Neck v4, on our site.✏️ For the sake of simplicity, the images in this documentation have been generated on a single fret neck. Yours will likely be longer.Step 0: Prepare M3 threaded rodsStep 0a: Cut M3 threaded rodsUsing an Angle Grinder or a Hack Saw, cut your 2x 1000mm M3 Threaded Rods to:Regular Scale Neck: 650mmShort Scale Neck: 610mmStep 0b: Smooth edgesYou want to deburr the end you cut. I like to use a belt sander.Step 1: Insert M3 Square Nuts into Chunk #1Step 2: Screw threaded rods into Square Nuts💡 Make sure to only thread it in very slightly, you will tighten these later, and you will want as much length as you can get before that.Step 3: Assemble NeckYour neck has 24 frets, please repeat these steps for all 24 of themStep 3a: Put in rubber band / GlueRecommended setup is Glue, but if you want to dissassemble the neck in the future use a rubber band instead.Either loop a 10mm thin rubber band around both M3 Threaded rods and slide it down to the previous neck…