Sink strainer

Ücretsiz STL Diğer

14 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Açıklama

A strainer for kitchen sink. Didn't have a tool available to measure the hole diameter, so I measured the outer rim of a steel strainer. It is 84 mm. That was close to dropping in the hole, and since previous printed strainer had shrunk from hot water, this one was intentionally oversized slightly to account for that. Printed in PETG. It will be tight at first. After dumping boiling water, followed by cold water, on it a few times, it will reached its maximum shrinkage (~ 1mm). It's now a zero gap fit that is easy to remove and install. 84 mm at top with a 2mm taper to bottom, 27 mm below. Walls are 3 mm thick. For those that do not want to sign up to download this, I have made it available on my Odysee channel... https://odysee.com/@HOWIC:d/sink-strainer:b

Bu model hakkında

Sink strainer, Cults3D topluluğunda paylaşılan ücretsiz bir Diğer 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.