简介
A strainer for kitchen sink. Didn't have a tool available to measure the hole diameter, so I measured the outer rim of a steel strainer. It is 84 mm. That was close to dropping in the hole, and since previous printed strainer had shrunk from hot water, this one was intentionally oversized slightly to account for that. Printed in PETG. It will be tight at first. After dumping boiling water, followed by cold water, on it a few times, it will reached its maximum shrinkage (~ 1mm). It's now a zero gap fit that is easy to remove and install. 84 mm at top with a 2mm taper to bottom, 27 mm below. Walls are 3 mm thick. For those that do not want to sign up to download this, I have made it available on my Odysee channel... https://odysee.com/@HOWIC:d/sink-strainer:b
About this model
Sink strainer is a 免费 3D model in the 其他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
