Version2 Nitro starter adapter by Patrick Nitzsche

Version2 Nitro starter adapter by Patrick Nitzsche

Ücretsiz STL Sanat ve Heykel
  • 14 görüntülenme

Bu model MyMiniFactory üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

MyMiniFactory üzerinde görüntüle ↗

Açıklama

The starter is a lot in use for RC cars so version one broke after a while and the shaft just spinned around so in version two I added two screws to tighten the shaft. Needs 2pcs M3 nuts and 2pcs M3x12 hex screws. If your shaft is bigger than the design allows just drill it out a little bit and tighten the screws and it should still clamp. | Download free and paid 3D printable STL files

Bu model hakkında

Version2 Nitro starter adapter by Patrick Nitzsche, MyMiniFactory topluluğunda paylaşılan ücretsiz bir Sanat ve Heykel 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları MyMiniFactory üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller