Version2 Nitro starter adapter by Patrick Nitzsche

Version2 Nitro starter adapter by Patrick Nitzsche

免费 STL 艺术与雕塑
  • 16 次浏览

该模型托管于 MyMiniFactory。文件、图片及许可信息归原创作者所有。

在 MyMiniFactory 查看 ↗

简介

The starter is a lot in use for RC cars so version one broke after a while and the shaft just spinned around so in version two I added two screws to tighten the shaft. Needs 2pcs M3 nuts and 2pcs M3x12 hex screws. If your shaft is bigger than the design allows just drill it out a little bit and tighten the screws and it should still clamp. | Download free and paid 3D printable STL files

About this model

Version2 Nitro starter adapter by Patrick Nitzsche is a 免费 3D model in the 艺术与雕塑 category, shared by the MyMiniFactory community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on MyMiniFactory. Use the button above to open the original page and download it.

相似模型