35mm Riser for Flashforge AD5X Enclosure

Açıklama

This is a riser designed to raise the top of the AD5X enclosure, so the Bowden tubes don't scrape the lid. The pieces are named A4-A through D4-A to indicate their positions, and they are embossed to help identify each piece. The riser sites between the #3 and #4 pieces of the Flashforge enclosure kit. They do not screw into the piece below, but you can screw the #4 piece into the riser. In my opinion, the screws are unnecessary as the pieces stay in place just fine thanks to gravity. I printed mine at 0.20 layer height in the same position as they sit on the machine with supports under the bottom groove for the acrylic. The pieces were designed in TinkerCad by merging the top of the #3 piece and the bottom of the #4 piece from the FF kit.