StreamDeck support

StreamDeck support

Ücretsiz STL Diğer
  • 14 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Cults3D üzerinde görüntüle ↗

Açıklama

Support for StreamDeck 15 buttons with tilt degree adjustment. It is designed to be clamped on the base of the monintor (maximum 60mm monitor base width). Required for assembly: 3 Nuts 4mm (one for central axle and 2 others for rear monitor attachment). 1 Nut 3mm to fit the center screw 2 screws 4x60mm (depending on the bottom of the monitor base you will need either shorter or longer ones) 1 Screw 3x20mm for central fastening 1 Screw 4x20mm for the central shaft

Bu model hakkında

StreamDeck support, Cults3D topluluğunda paylaşılan ücretsiz bir Diğer 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları Cults3D üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller