Experimental dismountable pump to be operational.
- 14 次浏览
该模型托管于 Cults3D。文件、图片及许可信息归原创作者所有。
在 Cults3D 查看 ↗简介
16:37 19 Mard 202, I see that the output may be reversed there on picture, seems to me that the shaft motor facing is anti-rotational, it seemed to me to have paid attention, but? Nothing extraordinary, but I found my lost files of a removable and modifiable pump. 1st option water detection pre-chamber engine. Before intervening on diameter, turbine thickness, make a test of flow, height lifting, intensity of the motor, turn minute requires me a DIY. Why? Because 8-10A gives me as much as 3-5 Amp, at a lift author 5-10m. Of course the one lifts the water much higher and constantly draws 8-10A. 5 Ampere, possible to run on a model battery with bms, solar panel and run intermittently.... I will come back
About this model
Experimental dismountable pump to be operational. is a 免费 3D model in the 数码配件 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.