简介
This is part of my automation initiative in my house. I have recently installed a ventilation system and since I wanted to be able to control the fan speed via my smarthings system I looked for a Z-wave or Zigbee fan speed regulator. This was hard to find so I therefore went for a manual knob.....but there is always a workaround :D Since I had a ESP8266 I started investigating how to connect it to Smartthings. ST_Anything was the solution - this brilliant device handler enables you to connect almost any cheap sensor/relay to your smart home....I finally understand the power of IOT!! Remove the manual knob and insert the body part. Glue a servo arm to the servo arm part. I also glued the SG09 servo to the servo mount part. Install the servo mount part. Connect it to your ESP8266 board after configuring it and voila - your manual knob can now be controlled from your phone and be included in automations!! Attached is a video of the knob in action https://www.youtube.com/watch?v=7xUWwEs0FlE The full explanation of my Smarthome ventilation system will be uploaded to my diy blog: http://www.diygarageprojects.com/
About this model
Fan Speed Regulator Automation is a 免费 3D model in the 其他 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
