Speedlight Double Mount

Speedlight Double Mount

免费 STL 数码配件
  • 26 次浏览

该模型托管于 Cults3D。文件、图片及许可信息归原创作者所有。

在 Cults3D 查看 ↗

简介

This double holder for speedlights allows you to use two speedlights on one umbrella holder at the same time, thereby doubling the light intensity. ColdShoe Double Flash Holder1 and ColdShoe Double Flash Holder Spigot assembled together form a complete printed system, as shown in the picture. Depending on the print quality, you may need to sand down the opening for the spigot slightly and then insert the assembled spigot with superglue. If you have separately available metal spigots and 1/4-inch screws, you can use them together with ColdShoe Double Flash Holder2. Print everything with 100% infill and in 0.16 mm layers for maximum strength. I printed it with PLA and it holds up perfectly. Nevertheless: use at your own risk! Have fun and good luck with it ;) https://youtu.be/dCFX0nVFoUs

About this model

Speedlight Double Mount is a 免费 3D model in the 数码配件 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

相似模型