简介
Vise version 2.1 Fixing points on worktop: 50x50mm (M4) A250 both base bodies are identical and can be fitted with square nuts (M6). The inlets for these are continuous so that the nuts can be easily replaced. The square nuts must be pressed in slightly. Otherwise, rework the inlets a bit. Hex nuts don't fit, but could be used with rework as well. On the screw head side, the holes are smaller, so that a thread can still be cut there !!!! Attention !!! From the side of the clamping jaw after the nut is inserted, so that the thread runs according to the nut. The thread in the base body serves to prevent the screws from simply loosening themselves. On the clamping jaw side, M6 easily fits through. Whether 1, 2, 3 screws are used ... everyone must decide for themselves.
About this model
Vise version 2.1 - Snapmaker A250 is a 免费 3D model in the 兴趣与DIY category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.
File formats
- STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.
The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.
