Pool Umbrella Stand Insert

Pool Umbrella Stand Insert

Kostenlos STL Gadgets
  • 19 Aufrufe

Dieses Modell wird auf Thingiverse gehostet. Dateien, Bilder und Lizenzangaben gehören dem ursprünglichen Designer.

Auf Thingiverse ansehen ↗

Beschreibung

This is an umbrella pole insert for the Sofun 60 lb. Plastic Patio Umbrella Stand. The stand itself can be used as either a planter or a table, and this insert is for the table top.The problem I faced is the hole is too large. Not only does it look unfinished, it allows the pole to move. This takes care of both problems.I measured as follows:inner - 38mm (umbrella pole)outer - 50mm (table top)This print provides for 1mm of clearance and can be snapped into two pieces for easier insertion / removal.

About this model

Pool Umbrella Stand Insert is a kostenlos 3D model in the Gadgets category, shared by the Thingiverse community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Thingiverse. Use the button above to open the original page and download it.

Ähnliche Modelle