Pool Umbrella Stand Insert

Pool Umbrella Stand Insert

免费 STL 数码配件
  • 23 次浏览

该模型托管于 Thingiverse。文件、图片及许可信息归原创作者所有。

在 Thingiverse 查看 ↗

简介

This is an umbrella pole insert for the Sofun 60 lb. Plastic Patio Umbrella Stand. The stand itself can be used as either a planter or a table, and this insert is for the table top.The problem I faced is the hole is too large. Not only does it look unfinished, it allows the pole to move. This takes care of both problems.I measured as follows:inner - 38mm (umbrella pole)outer - 50mm (table top)This print provides for 1mm of clearance and can be snapped into two pieces for easier insertion / removal.

About this model

Pool Umbrella Stand Insert is a 免费 3D model in the 数码配件 category, shared by the Thingiverse community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Thingiverse. Use the button above to open the original page and download it.

相似模型