Practice Lock Holder by .

Practice Lock Holder by .

Kostenlos STL Gadgets
  • 13 Aufrufe

Dieses Modell wird auf MyMiniFactory gehostet. Dateien, Bilder und Lizenzangaben gehören dem ursprünglichen Designer.

Auf MyMiniFactory ansehen ↗

Beschreibung

A holder for practice locks. The other holders I found on Thingiverse were way too small to fit my locks, so I made my own. There are tabs that prevent the locks from sliding out without some effort.The center plug snaps into place for storage and transport, or you can insert it from the back and it will provide a secure way to hold the entire assembly with a vise or act as a kickstand. This was designed for lock cylinders with a diameter of 16mm and a riser (pin housing?) width of 6mm. | Download free and paid 3D printable STL files

About this model

Practice Lock Holder by . is a kostenlos 3D model in the Gadgets category, shared by the MyMiniFactory community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on MyMiniFactory. Use the button above to open the original page and download it.

Ähnliche Modelle