Practice Lock Holder by .

Practice Lock Holder by .

免费 STL 数码配件
  • 15 次浏览

该模型托管于 MyMiniFactory。文件、图片及许可信息归原创作者所有。

在 MyMiniFactory 查看 ↗

简介

A holder for practice locks. The other holders I found on Thingiverse were way too small to fit my locks, so I made my own. There are tabs that prevent the locks from sliding out without some effort.The center plug snaps into place for storage and transport, or you can insert it from the back and it will provide a secure way to hold the entire assembly with a vise or act as a kickstand. This was designed for lock cylinders with a diameter of 16mm and a riser (pin housing?) width of 6mm. | Download free and paid 3D printable STL files

About this model

Practice Lock Holder by . is a 免费 3D model in the 数码配件 category, shared by the MyMiniFactory community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on MyMiniFactory. Use the button above to open the original page and download it.

相似模型