Practice Lock Holder by .

Practice Lock Holder by .

Ücretsiz STL Gadget ve Aksesuar
  • 12 görüntülenme

Bu model MyMiniFactory üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

MyMiniFactory üzerinde görüntüle ↗

Açıklama

A holder for practice locks. The other holders I found on Thingiverse were way too small to fit my locks, so I made my own. There are tabs that prevent the locks from sliding out without some effort.The center plug snaps into place for storage and transport, or you can insert it from the back and it will provide a secure way to hold the entire assembly with a vise or act as a kickstand. This was designed for lock cylinders with a diameter of 16mm and a riser (pin housing?) width of 6mm. | Download free and paid 3D printable STL files

Bu model hakkında

Practice Lock Holder by ., MyMiniFactory topluluğunda paylaşılan ücretsiz bir Gadget ve Aksesuar 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.

Dosya formatları

  • STL — 3D baskı için en yaygın mesh formatı — neredeyse her yazıcıda dilimlenip basılmaya hazır.

Bu modelin dosyaları MyMiniFactory üzerinde barındırılır. Orijinal sayfayı açıp indirmek için yukarıdaki düğmeyi kullan.

Benzer modeller