Fishing line Hinge alignment tool

Fishing line Hinge alignment tool

無料 STL ツール
  • 25 閲覧

このモデルは Cults3D で公開されています。ファイル・画像・ライセンス情報は元の作者に帰属します。

Cults3D で見る ↗

説明

Use 20 lb. fishing line as a hinge for small RC airplanes. Simply place tool with prongs over item. Twist until prongs touch top and bottom of item. Then use "t" pin or Drill a 0.023" hole in the center of the alignment tool ( approximately 3/8" deep. Repeat this on the other part. Make the hole(s) with one of the following suggestions: * Pin vice #106 * Drill bit 0.023" * Tee Pin Make sure your holes are aligned on both parts. You can place masking (or other low tack take such as frisket film, etc.) and mark both parts in alignment with each other.

About this model

Fishing line Hinge alignment tool is a 無料 3D model in the ツール category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

類似モデル