Fishing line Hinge alignment tool

Fishing line Hinge alignment tool

免费 STL 工具
  • 27 次浏览

该模型托管于 Cults3D。文件、图片及许可信息归原创作者所有。

在 Cults3D 查看 ↗

简介

Use 20 lb. fishing line as a hinge for small RC airplanes. Simply place tool with prongs over item. Twist until prongs touch top and bottom of item. Then use "t" pin or Drill a 0.023" hole in the center of the alignment tool ( approximately 3/8" deep. Repeat this on the other part. Make the hole(s) with one of the following suggestions: * Pin vice #106 * Drill bit 0.023" * Tee Pin Make sure your holes are aligned on both parts. You can place masking (or other low tack take such as frisket film, etc.) and mark both parts in alignment with each other.

About this model

Fishing line Hinge alignment tool is a 免费 3D model in the 工具 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

相似模型