Fishing line Hinge alignment tool

Описание

Use 20 lb. fishing line as a hinge for small RC airplanes. Simply place tool with prongs over item. Twist until prongs touch top and bottom of item. Then use "t" pin or Drill a 0.023" hole in the center of the alignment tool ( approximately 3/8" deep. Repeat this on the other part. Make the hole(s) with one of the following suggestions: * Pin vice #106 * Drill bit 0.023" * Tee Pin Make sure your holes are aligned on both parts. You can place masking (or other low tack take such as frisket film, etc.) and mark both parts in alignment with each other.