IRobot Braava Jet 250 Wall Mount

Ücretsiz STL Gadget ve Aksesuar

20 görüntülenme

Bu model Cults3D üzerinde barındırılıyor. Dosyalar, görseller ve lisans bilgileri tasarımcısına aittir.

Açıklama

iRobot Braava Jet 250 Wall Mount that I designed to store the robot mop out of the way on the wall. May also fir the Jet 240 but I don't have this to test. Holds the robot upright using the battery mount and is a friction fit. Make sure there is no water left before storing otherwise it will leak out. There are Four screw holes to attach to the wall as the robot is reasonably heavy and so I would not trust sticky pads to be strong enough unless you have a clean surface to stick to. Printed at 25% gyroid infill with 4 walls for strength as the part is constantly under the weight of the robot. Printed in orientation as per the STL (i.e. flat wall part down on the plate) with support for critical areas only.

Bu model hakkında

IRobot Braava Jet 250 Wall Mount, Cults3D topluluğunda paylaşılan ücretsiz bir Gadget ve Aksesuar 3D modelidir. 3D baskı için indirebilir ve orijinal lisans koşulları çerçevesinde kendi projelerinde kullanabilirsin.