IRobot Braava Jet 250 Wall Mount

IRobot Braava Jet 250 Wall Mount

免费 STL 数码配件
  • 24 次浏览

该模型托管于 Cults3D。文件、图片及许可信息归原创作者所有。

在 Cults3D 查看 ↗

简介

iRobot Braava Jet 250 Wall Mount that I designed to store the robot mop out of the way on the wall. May also fir the Jet 240 but I don't have this to test. Holds the robot upright using the battery mount and is a friction fit. Make sure there is no water left before storing otherwise it will leak out. There are Four screw holes to attach to the wall as the robot is reasonably heavy and so I would not trust sticky pads to be strong enough unless you have a clean surface to stick to. Printed at 25% gyroid infill with 4 walls for strength as the part is constantly under the weight of the robot. Printed in orientation as per the STL (i.e. flat wall part down on the plate) with support for critical areas only.

About this model

IRobot Braava Jet 250 Wall Mount is a 免费 3D model in the 数码配件 category, shared by the Cults3D community. You can download it for 3D printing and reuse it in your own projects under the terms of its original license.

File formats

  • STL — The most common mesh format for 3D printing — ready to slice and print on almost any printer.

The files for this model are hosted on Cults3D. Use the button above to open the original page and download it.

相似模型